Coloration

Step 1: Preparation

• Do not wash your hair 24–48 hours before colouring.
• Put on the gloves and wear a protective clothing cover.
• Have a clock ready to monitor the exposure time, as well as a hair clip (non-metallic).
• Apply half of the Bonding Pre-Serum (1) evenly to the lower section of hair.
• Remove the clip from the top hair and apply the rest of the Bonding Pre-Serum (1) to the lengths.
• Thoroughly comb your hair.
• Open the tube of the Bonding Colour Cream (2A) by piercing the aluminium foil with the top of the cap.
• Press the entire contents of the Bonding Colour Cream (2A) into the application bottle (2B) with the cream developer.
• Close the application bottle (2B) and shake until a smooth cream forms.
• Break off the tip of the closure of the application bottle (2B) and start the application immediately.

Step 2: Application

• Option 1: Root Treatment
  1. Section the hair with the applicator tip in parts.
  2. Apply the mixture along the parting and completely cover the roots.
  3. Use ⅓ of the colour mixture for the regrowth area.
  4. Leave the colour mixture on for 20 minutes (for colour shades 10-0 and 10-19: 35 minutes).
  5. Distribute the remaining mixture over the entire hair and leave it on for another 10 minutes.
• Option 2: Full Application
  1. Apply the prepared mixture directly from the application bottle evenly to the hair roots.
  2. Distribute the remaining mixture strand by strand in the lengths and work it in thoroughly.
  3. Leave the colour mixture on for 30 minutes (for colour shades 10-0 and 10-19: 45 minutes).

Step 3: Rinse and Aftercare

1. Put the gloves back on.
2. Lather the hair with some warm water and rinse thoroughly until the water runs clear.
3. Distribute the Bonding Hair Mask (3) in towel-dried hair, avoiding the roots.
4. Leave the mask on for 5 minutes.
5. Rinse the mask thoroughly out.
6. Keep the mask and use it up to 4 times for easily manageable and noticeably soft hair.